Trifive left overs-trade or sell-

[dgas]

These are all extra's, take off or up graded parts.
-Used HLT bezels $20 (2 pr)
-55 New gas door gaurd $20
-Used 55-7 front windhield + back glass trim - all pcs $40 ea end
-57 BA 2 door door trim mldng-drivers side,$15
-55 BA front door and fender mldng set $75 fronts are dented but savable.
-Used 55 grille and trim pcs inc hood bar -driver Qlty some pitts $75
-1955-57 orig. Master Cyl. Current unit just out of driving car on 2-5-10- MINE $45
-55 hood dented but a good scoop candidate. $50
-57 Belair arm rest brackets have couple sets $10 a set
-57 bumper bullet covers $15 a pr
-57 heater bezel $10
-55 dash speedo cluster $25
-55 dash trim panels ends are nice but center has gauge holes $20
-55-7 Cast iron thermostat housing cleaned and painted correct black $10
-Misc SOLID southern doors -4dr $40 ea.
-55-7 nice sedan deck lid $50
-55-7 six cyl motor mount bracket, (one side for sure have to check on what side)$5
-Misc used lenses $2 ea.
-Used 55 210 + BA 4dr/wgn door/qtr mldngs
-Used Belair 4dr/wgn mldngs
-Front brake drums, backing plates and internals- both off running driving cars after disc conversions, one set w NEW line and wheel cyls $65 and $90
-2 1955 St Wgn rear bumpers both off of drivers, but in need of rechrome ,gaurds are shot on both $75 ea. No brackets
-used 55 front bumper and gaurds drivers Quality,NICE gaurds but center in over bent in a sort of V $75
-Wgn rear seat and all attaching parts (U PULL) $90
-NEW front disc brake hoses for 68-77 caliper both sides including new thru bolt set never installed $15 pr
-St Wgn (4dr) drivers side rear side glass (U Pull) $60
+ a few more bits n pcs.
I also have two full sets of Chev rally wheels (4-15x7 and two 15x7/two 15x8's)

Probably a waiste of space as I'd like to NOT ship this stuff so more for local to Mn guys but I will ship the small parts if they fit in those USPS prepaid boxes. But I will those IF you have time to wait. I am not big on shipping anything large (hard for me to get out,boxes are hard to find and too expensive to pay a shipper to do.) My health restricts my pulling some of the above parts (1 Wgn bumper ,seat and glass) at least until spring. I would rather trade than sell. I will Trade the above for parts I need- working NEW or restored only, I have all the cores I need.
Mike @ 320 968 7434

[Bodyman]

I was interested in the fender and door chrome,would you have a picture.

[dgas]

Meant to get out and take pics but we have had a storm the last few days (and still in it, could be another 4" tonight and tomorrow on top of the 7.5" we got now) so the garage doors are snow blown in, I'll get them, hopefully dug out tomorrow. I do have a mailing tube for these.

[CamaroMark]

im wondering how much the grill, and trim, and hood bird would cost to ship to canada??? i may be interested if the shipping wont kill me

[dgas]

I am betting it would not be cheap, I'll measure them and get back to you

[JEFFS56]

D-Gas just a trick I seen used, plastic drain pipe or sewer pipe.. to ship chrome in,., its cheap and comes in 10 ft lenghts .. and weighs very little , you dont have to buy the heavy stuff.
I got both side chrome for a 57 ,, 2 door shipped to me that way ,shipping was 10 or 11.00 plus I had to pay the 5>00 for the plastic . I thought it was very reasonable ..
JEFF

[dgas]

I have used that way too. Right now I have plenty of mailing tubes left over from buying parts for my 55 and our recent house remodel to reuse, I think I would plastic tie strip the grille trim right to the grille for shipping if it sells, Our storm just ended a few hours ago so It will be cold today and tomorrow. But I expect to start pulling my 55 apart Thursday. The 55 wgn parts car on the other hand is now completely buried out in the back 40 at the farm so that is going to be awhile to get at.

[dgas]

front mouldings
#1 pass front fender
#2 Pass door
#3drivers front door
#4 driver fender