My hauler

[Wrenchbender]

Well bluedot it all depends on what I get done in the next couple weeks it's close

[Wrenchbender]

Even though it was extremely cold today I was so bored I decided to take a break from the customer car and do something on my own crap today I fired up the ol 55 and drove it in the garage fired up the heater and actually made some progress on the wagon today I managed to get all the rusty floors cut out and prepped for new panels hopefully tomorrow I can get some new floors welded in then I can start reassembling this thing and get it ready to drive this spring

[Wrenchbender]

Well after an all day ordeal I managed to get the drivers floor pan made and installed I also got the passenger pan fabricated but now I just have to weld it in the rear pans will be a lot less fabrication to make as they are just basically a flat panel the fronts had to be drilled for spot welding and bent for the toe pan not to mention body mount holes put in the correct spot. After I get the pass pan welded in I can fab up the trans tunnel after that I can reinstall the dash finish the wiring and reassemble everything else

[Wrenchbender]

Pass floor pan is in progress is happening

[Wrenchbender]

Trans tunnel is made now slowly but surely I'll get this thing done lol

[jimmy1931]

Trans tunnel is made now slowly but surely I'll get this thing done lol

It is great when a plan starts to come together!

[Wrenchbender]

Jimmy you are right it's nice when things tend to come together made more progress this weekend the rear floor in this thing had been hacked out with a hatchet so I spent a good amount of time straightening and hammering the hacked up tunnel back into shape and then welded it back together then made a patch to repair the missing piece of the tunnel and welded it it then it was onto the pass rear floor pan so I rolled some beads into it and bent it into shape and tacked it in I have a bit more finish work to do but if all goes well I'll have the floors finished up this week stay tuned more to come

[Wrenchbender]

Guess I need to update a bit I managed to get all the floors finished up a while back and have been on the lookout for a lot of window trim parts that were either badly damaged or just flat out missing but thanks to Jim aka the human wrench I was able to acquire all the needed parts so since it was a nice day on. Sat I made a trip to drag city and drug home a donor car that has all the rest of the needed parts either on it or inside it lol so stay tuned progress is on the way

[Bluedot]

Randy, have you decided on color(s) yet?

[Wrenchbender]

Bluedot paint is a long ways off at this point and really haven't thought that much about it probly will just be red and white like the dragster I'm just trying to get it on the road right now